Hyline-offroad CJ LOUVERED HOOD PANEL User Manual download pdf (Page 2)

***BEFORE INSTALLING***

If you ordered the Hood Louver Panel raw you should paint, anodize, powder coat, etc. now before

installation onto vehicle. PEEL OFF THE VINYL PROTECTANT COVERING BEFORE PAINTING OR

FINISHING. If Hood Louver Panel was was ordered black powder coated your now ready to continue

to step 1.

Hood Louver Panel Installation

Step 1 – As a safety precaution - Remove the hood from your vehicle before drilling or cutting. First, remove the

engine grounding strap, hood light, and/or windshield washer hose from hood, if applicable. Then unbolt

the 4 bolts from the hood hinges. Hood should now be free to remove from vehicle.

Step 2 – Once the hood is removed, place the hood on a flat, solid work area. Then remove the windshield

u-shape tie down bracket in center of hood. Tie down bracket unbolts from under the hood.

Step 3 – Place steel template in the center of hood as seen

in (Figure 1). **Picture may vary from your Template.**

Visually make sure the holes in the template are centered

with the holes for the windshield tie down bracket.

Step 4 – Re-install the U-Shape tie down bracket and tighten nuts

securely, as these will hold the template in place while drilling

in Step 6.

C:\Users\RHerd\AppData\Local\Temp\CJ-50HLP InstallationInstructions.doc Page 2 of 4

REV 0 06/17/09

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION

Figure 1

1 2 3 4

No comments

Hyline-offroad CJ LOUVERED HOOD PANEL User Manual Page 2