Hyline-offroad JK TUBE STEP ROCKER PANELS (4 DOOR MODELS) User Manual download pdf (Page 3)

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.100-JK TUBE STEP ROCKER 4 DOOR\400.300.100 Installation Instructions.doc

Page 3 of 4

REV 1 04/16/13

7. Now install the supplied 3/8-16 Threaded U-Bolts by inserting one end first, then feeding and turning the U-Bolt

until you fish it out the other hole. Do this before installing the Rock Sliders. Press on the provided Retaining Rings

immediately after the U-Bolt is installed to prevent from slipping into frame. (Figure 2)

8. Now you’re ready to install the Rock Slider (Much easier with two people).

Slide the Rock Slider Brackets between the skid plate mounts and frame rail

and install the two stock bolts into the bottom. Also install the supplied M12

bolt with lock washer & flat washer in forward most hole.

DO NOT TIGHTEN YET.

9. Fasten the 3/8-16 Hex Nuts onto U-Bolts with flat washers and lock washers.

Do Not Overtighten These Nuts.

10. Tighten all other bolts on the bottom of the frame.

11. The installation of the Passenger Side Rock Slider is now complete.

Driver Side Installation:

12. Remove the existing bolt from underside of frame rail. This bolt will

be in the center of the frame rail.

13. Insert the Driver Side steel drill template (RED Dot) between skid

plate crossmember and the frame rail. Hold up the template and install

one of the supplied M12 bolt and flat washer into the forward most hole.

Then re-install the other bolt you previously removed. The Driver

Side does not have an existing hole for the rear most location. There is

a hole in the template where you’ll need to drill.

Figure 2, U-Bolt Shown without Rock

Slider For Clarity. Install with Rock

Slider In Place

Figure 3 – U-Bolts Installed & Fastened

1 2 3 4

No comments

Hyline-offroad JK TUBE STEP ROCKER PANELS (4 DOOR MODELS) User Manual Page 3