Hyline-offroad TJ/YJ TIRE CARRIER READY REAR BUMPER User Manual download pdf (Page 3)

T:\Hyline Offroad, LLC\Installation Instructions\TJ-YJ-20SRB\TJ-YJ-20SRB Installation Instructions.doc Page 3 of 3

REV 2 6/1/2010

allows for installation of bolts through all eight mounting holes if applicable. For YJ Models you will not

Install Spacer Shim in between rear cross

member and Frame Tie-in Bracket.

Figure 2

Step 3 – Some TJ Models may have eight mounting holes in the rear cross member, but most will only have

four. All YJ Models should have eight mounting holes in the rear cross member. Our rear bumper

be installing the Frame Tie-in Brackets.

For TJ’s you will install two bolts on each side using supplied

7/16-20 x 1-3/4” Bolts. Install parts in the following order:

Bolt, Flat Washer, Lock Washer, Tie-in Bracket, & Spacer Shim.

(SEE FIGURE 2) Re-install the two bolts you took out of from the

bottom of the stock bumper. BE CAREFUL NOT TO CROSS THREAD

THE 7/16-20 x 1-3/4” BOLTS WHEN THREADING INTO THE BUMPER.

For YJ’s you will install four bolts on each side using supplied

7/16-20 x 1-3/4” Bolts. You will not be installing the Frame Tie-in

Brackets on the YJ Model.

Step 4 – Tighten all bolts and torque to 75-78 ft/lbs. After about 50-100 miles of driving re-check all bolts and

torque to proper settings.

Send your OFFROAD pictures to [email protected] . If we choose any one of your pictures to be used on

our website, We send you a FREE Hyline Offroad T-Shirt.

Installation instructions provided must be read and followed exactly when installing

product. Failure to do so could potentially result in injury or death of any occupants

in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!

Though our products are rugged, they are primarily designed and built to enhance the appearance of the

vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle

manufacturers specifications

Attention

Note: If installing a Tire Carrier you may need to keep the Gr8 Bumper

Mounting Bolts loose in order to install the Tire Carrier & Pivot Pin. Refer

to “NOTE” at Ste

4 in Installation Instruction Packet for TJ-YJ-20STC.

1 2 3

No comments

Hyline-offroad TJ/YJ TIRE CARRIER READY REAR BUMPER User Manual Page 3